RCSearch
  • Anmelden
  • Einloggen
Join to our channels: new products, coupons, best deals:

Walksnail Avatar drones

RC FPV in winter
Multirotors
FPV
Helicopters
Transmitters
Airplanes, aircrafts, flying wings
Battery Chargers
Batteries
Robots
Electronics
Boats
RC Cars
Brands
Fasteners
Fun Club & Merch
DJI
Backpacks & Cases
Workbench
Arduino World

Happymodel Moblite7 1S 75mm Walksnail BNF 2.4GHz ELRS SPI

FPV → HD Video Links → Caddx Walksnail Avatar HD → Walksnail Avatar drones → Happymodel Moblite7 1S 75mm Walksnail V2 BNF 2.4GHz ELRS SPI → Happymodel Moblite7 1S 75mm Walksnail BNF 2.4GHz ELRS SPI
Happymodel Moblite7 1S 75mm Walksnail BNF 2.4GHz ELRS SPI

Specification:

Brand: Happymodel

Model: Moblite7 Walksnail

Item Name: 1S 75mm HD Whoop FPV Racing Drone

Frame wheelbase: 75mm
Weight: 33.5 gram without battery
Size: 98mm*98mm*48mm
Receiver option:
SPI ELRS 2.4GHz
SPI FRSKY 2.4GHz
Compatible with 1S Lipo battery or Lihv battery
Battery Plug: PH2.0


Flight controller
SuperbeeF4 Lite ELRS/FRSKY
SPI ELRS version Firmware target: CrazybeeF4SX1280
SPI FRSKY version Firmware target: CrazybeeF4FR
MCU:STM32F411CEU6 (100MHz, 512K FLASH)
Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)
Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in SPI Frsky/ExpressLRS receiver
Built-in 5V 1A BEC
Built-in voltage detection
Onboard 4in1 ESC

MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)

Currents: 5A continuous peak 6A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_5_REV16_8.HEX
Default protocol: DSHOT150/DSHOT300/DSHOT600

Onboard SPI ExpressLRS 2.4GHz Receiver
Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHz
Telemetry output Power: <12dBm
Receiver protocol: SPI ExpressLRS
Could bind with ELRS V2.0 firmware TX module
Onboard Frsky SPI D8 /D16 2.4GHz Receiver
SPI BUS receiver Frsky D8/D16 compatible
Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol
MotorModel: RS1002 20000KV
Configu-ration:9N12P
Stator Diameter:10mm
Stator Length:2mm
Shaft Diameter:Φ1.5mm
Motor Dimension(Dia.*Len):Φ13.5mm*12.5mm
Weight(g):2.5g
No.of Cells(Lipo):1S only
Propeller Gemfan 1610-2 Bi-blades
Weight:0.24g
Material: PC
Pitch:1 inch
Props Dia:40mm
Center Hole Dia:1.5mm
VTX

Model: Avatar mini 1s module
Communication Frequency: 5.725-5.850 GHz
Transmitter Power(EIRP): FCC:<25.5dBm; CE:<14dBm; SRRC: <20dBm;MIC:<25dBm
l/o Interface: JST1.O*6(Power in)JST1.O*4(USB)
Mounting Holes: 25.5*25.5 mm
Dimensions: 33*33*6.5 mm
Storage: 8G
Recording: 1080p/720p
Weight: 6.8 g
Operating Temperature: -20-40℃
Channels: 8
Wide Power lnput: 3.1V-5V
Supported FC System: Betaflight
OSD: Canvas mode

Bitrate: 25mbps / 50mbps
Latency: Average delay 22ms
Antenna connector: IPEX

FPV CameraModel: Avatar nano
lmage Sensor: 1/2.7”Inch
Resolution: 1080P/6Ofps,720P/120fps,72OP/6Ofps
Ratio: 16/9 4/3
Lens: 2.1mm
FOV 170°
Aperture: F2.0
Shutter: Rolling shutter
Min.Illumination: 0.001Lux
Weight: 3.5g
Dimensions: 14*14*17mm
Coaxial Cable: 45mm


Package Included:

1x Moblite7 Walksnail FPV Drone

1x Spare Canopy

1x Propeller disassemble tool

1x Screw driver

Share

Preise für Happymodel Moblite7 1S 75mm Walksnail BNF 2.4GHz ELRS SPI in den Läden

Angebote gefunden: 15 ()

Siehe auch

Happymodel Moblite7 1S 75mm Walksnail Avatar BNF Frsky
Happymodel Moblite7 1S 75mm Walksnail Avatar BNF Frsky
$206
Happymodel Moblite7 1S 75mm Walksnail V2 BNF 2.4GHz ELRS SPI
Happymodel Moblite7 1S 75mm Walksnail V2 BNF 2.4GHz ELRS SPI
$260
Happymodel Moblite7 parts
Happymodel Moblite7 parts
Join to our channels: new products, coupons, best deals:
Copyright © 2011—2025 | RCSearch | Das Manytsches Projekt
↑