Happymodel CrazybeeF4 PRO V3.1 12A 4S Frsky SPI D8

Happymodel CrazybeeF4 PRO V3.1 flight controller built-in 12A Blheli_s ESC and Diversity 2.4g SPI Frsky Receiver for Cine8 Drone

Specification:
Flight controller
Firmware target: MATEKF411RX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 2-4S battery input (DC 7V-17V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5V 1A BEC

Onboard 4in1 ESC
MCU upgraded to EFM8BB21
Power supply: 2-4S LiPo/LiPo HV (7v/17v)
Current: 12A continuous peak 15A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: F_H_40_REV16_8.HEX
Default protocol: DSHOT600

Onboard Frsky SPI D8 receiver Version
CC2500 Hardware
Compatible with FrskyD FrskyX Frsky_X_LBT SFHSS REDPINE protocol
Channels: 8ch
Failsafe support
Diversity 2.4G receiver system
No ground interference: above 300meter

This flight controller is already pre-solder buzzer , external receiver wires, 5pin vtx wires(just plug to Happymodel Whoop_vtx or Whoop_vtx_hp or Diamond VTX) and also the xt30 power wires .

It’s easy to build your own FPV drone with this AIO flight controller

Package Included:
1*CrazybeeF4 PRO V3.1 flight controller