Flyduino KISS F7 FC V2

Before Purchasing: Please keep the packaging after receiving KISS flight controller. Each genuine KISS FC has a unique serial number on the packaging, while fake KISS FC does not and can not be activated. Flyduino, the designer and manufacturer of Kiss FC, will offer the technical support only to the ones with serial numbers. If the packaging is lost, you may fail to get the technical support from Flyduino in time. Besides, for any return of KISS products, you will need to send back the KISS packaging as well.

Finally Flyduino release the KISS V2 flight controller with a F7 processor. As an authourized dealer of Flyduino, HiModelUAV is one of the first to receive the FCs. 

A new simplified Flight controller, the KISS FC V2 includes a complete own Flight Control Firmware development. The Idea was to get the simple KISS FC to the next level and due to intensive long term tests of some pretty good Pilots we were able to optimize the code to a point where you hopefully get your quad in the air quite quick.

Normally you just need to choose your Airframe in the GUI and you are able to fly (at least with KISS ESC), otherwise you can download presets of well known pilots for given configurations. And of course you can tweak the PID yourself through the GUI.

The software setup side is reduced as far as we could, many things are already taken into account for you, if you have some solid soldering skills you should be able to build your quad pretty quick. A known feature is also the telemetry, in combination with our 32bit ESC line it‘s possible to show the live telemetry data via OSD on your FPV live feed or in the KISS FC GUI. This way you get useful informations like the Voltage of your battery, current consumption, ESC temperature and motor RPM. Other FC firmwares (eg. Betaflight) are ported for the use with the KISS FC V2.

ARM-Cortex M7 MCU

with FPU @ 216Mhz

for even the most complex algorithms. 
up to 12 times faster now.
 

Powered directly by the battery

(2-6S) max. 500mA @ 5V

avoids unnecessary weight.
 

Onboard USB

CP2102 USB-UART

USB controller for easy updates of FC and ESC directly via GUI.

Bidirectional communication

ultrafast Dshot 2400, sinHybrid and full Kiss Telemetry support.
 

Serial Monster

5 for all use cases.

Specifications

• MCU: STM32F722RET6 @ 216 MHz
• IMU: MPU6000
• Weight: 5g
• Mounting: 3x3cm  (mit 3,3mm L?chern)
• Voltage: 2-6S (direkt)
• Tri, Y4 and Y6 * Quad + / x * Hexa + / x

The needed USB driver will be installed when you connect the flight controller the first time. It could take several minutes till you can bind the flight controller to the GUI.

Supported FrSky Sbus, Graupner SumD, TBS CROSSFIRE and Multiplex SRXL as S-Port, HOTT, TBS CROSSFIRE and Sensorbus.

Turtle mode supported

5x Serial
RunCam Split supported
RGB Led supported
DShot 2400
FW via GUI
Advanced adaptive Filter
Advanced Motor Layout
Windows, OSX, Android supported

Wiring Diagram of Kiss FC V2-

Flyduino KISS FC V2 Connection Plan by Philipp Seidel.